Other Products: Ranger Heat Gun, Bone folder, Paper distressing tool, Hole pricking tool, Scissors, Ruler, Round inking tool, Distress Ink: Dusty Concord, Spellbinder dies: S4-5364 Phrase set 2 Thank You, Hot glue gun, Versa-mark, Scissors, Double sided Tape, Double Sided Foam Tape, Purple organza Ribbon, Misti, Purple card stock, Purple embroidery thread and needle, Bow maker
Instructions: This slider card when completed measures 7" x 8.1/2"(17.8 cm x 21.5 cm). Taking the white card stock cut to 11" x 8 1/2"(27.9 cm x 21.5 cm ). Along the 11 (27.9 cm ) length make 2 x folds at 2" (5.1 cm ). Make these into hill and valley folds. This will make a background of 7"(17.7 cm ) and the card foot to 2" (5.1 cm ). Taking the white card stock, cut a slider 3.1/2" x 3.1/2" (8.9 cm x 8.9 cm ) and the card front 7" (17.7 cm ) long x 5.1/2" (14 cm ) high. Taking the purple card stock cut a matting layer for all a little smaller. Find the design paper in the paper collection and cut to size once a gain a little smaller than the purple card stock. Ink the edges with the Dusty concord distress ink and inking tool. Prick holes along the edge of the card front design paper then embroider with thread using backstitch. Distress this edge with the paper distresser. Adhere this paper to the card by using the double side foam tape, the rest of the papers with clear drying glue or double sided tape.
Once the card has been made, make all the flowers and the leaves using the vellum paper and the white embossing powder. Color the flowers and leaves on the backside. Shape carefully as not to crack the embossing powder. Make a double triple bow from the organza ribbon. Taking the purple card stock die cut the sentiment five times then adhere the layers together. Adhere all the embellishments in their place. Apply the prills to the flower centres using the clear drying glue or the crystal lacquer. Apply the crystal lacquer to the sentiment.