Teardrop Daffodils

 Save Project to My Library

Teardrop Daffodils

Other Products: Memento Dandelion Ink, White Cardstock, Die Cutting Machine, Dimensional Tape, Hot Glue Gun

Instructions: My card size is 5 x 7”. I used the Teardrop Lattice Gateway Die and cut a shaped card out of white cardstock. I covered the base card with a piece of Sheet 7B from the paper collection. Cut out the largest die with the lattice areas using white cardstock and glue over the piece of the pretty paper.

Using the smaller dies in the set I cut out a piece of Sheet 2B from the paper collection and then used white cardstock to cut out the lattice piece. I used dimensional tape to adhere to the card base and give a bit of dimension.

I stamped the Large Daffodil from the Delightful Daffodil & Hyacinth using Rich Cocoa ink and colored using Dandelion Ink, Fern Green and Leaf Green ink. Cut out using the coordinating die.

Next, stamp the flowers and leaves and fillers for the card. I used Fern Green for the leaves and fillers and Dandelion for the Daffodils. I colored the Daffodils with Dandelion ink as well and cut out using the coordinating dies. The filler pieces were colored with Leaf Green and Majestic Violet and then use the coordinating dies to cut them out. Lay the Daffodils onto the mold, spritz with water and run through the die cut machine. Turn them out to dry. I used hot glue to put the daffodils together then poked a hole and run through the stamen and hot glued them into place.

Lots of glitter was sprinkled over these flowers and leaves and also on the lattice of the Teardrop Lattice Gateway Die.

The card is finished. I love how this card turned out...it is a definite statement piece!

Created By Glenda Brooks
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.