Sweet and Caring

 Save Project to My Library

Sweet and Caring

Instructions:

This is a 12” x 12” Layout. Taking the pizza box lid, cut this to 12“ x 12”. Make mark with a pencil and ruler at  6“  on two opposite edges.  Now taking both the sheets 1B from the Sweet Pea collection pad and cut these to the purple lace edge just shy of the green line as shown. Adhere the pale coloured paper to the pizza base opposite edges where the 6“ marks are not made. Once the flowers and leaves are made arranged and adhered in place, the two remaining paper strips will be adhered in place, until then prepare these by applying double sided tape or double sided 3D foam dots to these papers ready to adhere later.

To make the photo frame component: The photo used for this layout is 3 3/4“ x 5 3/4“. Adhere scrap cardboard to the back of the photo to strengthen and trim to size. Taking the fern green ink and a dauber to ink the edges of the photo then taking the sand paper sand all the edges of the photo. Using a paper from the collection that matches the layout back ground and the  Album Tags and Accents die, die cut two tag tops 2“ using the outer die of the large tag. Only 11/4“ of this tag will be seen when done. Taking the white card stock, die cut four lace frames from the Classic Floral Vase die set. Adhere glitter to the frames, by using the clear drying adhesive and the hydra sponges. Sandwich a tag between two frames so the lace peaks just over and under the tag top. Adhere together with the clear drying adhesive. Make one more with the remaining tag and frames. Adhere the tags to the underside of the photo, the right side lower than the left as shown.

Keeping two of the larger sweet pea vines apart for the next layer, you can now arrange the sweet pea vines and adhere in place using the photo frame and the two paper strips already prepared with 3D foam dots/tape as a guide as to the placements. Adhere the vines in place once you are happy with the placements then adhere the two paper strips in place using the 6“ marks to align the  placement. The remaining vines can now be adhered to each side of the layout so they will peak out from under the frame. Adhere the photo frame in place.

Make the sentiment for the layout: Die cut the larger letter font from the Letters and Numbers die set. There are 5 layers white card stock used and inked with the fern green ink and a dauber. Once adhered in place on the layout apply the crackle accents.

Adhere the 3D sweet pea flowers in place as pictured.

To make the flowers: Using the white card stock, the stamping sets Sweet Pea and Vining Sweet Pea, the sepia ink and the misti stamping tool. Stamp both the sweet pea vining images five times each and the small sized sweet pea images also five times, this will give you enough to make 5 3D sweet peas. Bring colour to the stamped images by using the Bright Green, Cypress, Blueberry pencils and the water brush. Bring shape to the 3D sweet pea flowers by using the matching mold and the deluxe flower shaping tools. Bring shape to the vining sweet peas by using the deluxe flower shaping tools.

Other Products: Inks: Spectrum Noir Aqua Pencils: Bright Green, Cypress, Blueberry. Other: diamond stickles, Sanding paper, Inking brush, 3D double sided foam tape, Double sided tape, Misti stamping tool, Ranger crackle accents, Pizza box lid / grey board , Scrap card board, Pencil and ruler, Water spritzer

Created By Susan Smit
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.