Sending You Birthday Love

 Save Project to My Library

Sending You Birthday Love

Other Products: White card stock, Inks: Spectrum Noir-Harmony Damson Wine, Foam inking tool, Versa-mark, Clear embossing powder, 3D double sided tape, Misti stamping tool.

For more ideas on creating with the Special Sentiments Stamps & Dies, watch the tutorial at https://youtu.be/-dYnAWXIH3E.

Instructions: When finished this tent fold card measures 6 3/4” x 6 3/4” (17.2cm x 17.2cm)

Using the white card stock, cut two pieces for the tent fold card base. 6 3/4” x 6 3/4” (17.2cm x 17.2cm) Make a fold at one edge of a card piece. 1/2” (1.5cm) Apply double sided tape to this then adhere both cards together for the tent fold. Apply the Pale Fig to the card front using a foam inking tool.

Find the paper on sheet 9a and cut this about 1/4” (1cm) smaller than the card front. Find the framed print and cut this to size. Ink the edges of both papers with the Pale Fig ink. Using the white card stock and the Sweetheart borders die, die cut 6 lace borders. Use 4 of the lace borders to form a frame along the card front. Adhere in place with clear drying glue then adhere the matting using double sided tape. The remaining two borders trim so they will fit to both corners. Adhere these to the back of the printed frame. Adhere this frame to the card front using the 3D foam circles.

To make the sentiment cluster: Stamp the sentiment with the Library green ink then with the versa-mark using the Misti stamping tool. Apply the clear embossing powder and heat set with the heat tool. Die cut the sentiment using the matching die. Adhere in place using the 3D circle foam dots. Make the flowers by using the flower shaping paper and the black ink. Stamp enough for two layers for three larger flowers, each with 5 stamens in the center and one layer for 9 smaller flowers, each with one stamen in the center. Stamp 5 leaf pairs. Die cut all with the matching dies then bring the color to the flowers and leaves. Green, Purples and pinks. Bring the shaping to the flowers and leaves using the matching 3D flower shaping molds. Thread the stamens in the center of the flowers then secure the stamens in place using the hot glue gun.

Adhere in place across the sentiment in a long trailing cluster using the hot glue gun. Finish the card by applying the 3D crystal lacquer to the sending you banner and the purple frame strip.

 

Created By Susan Smit
Copyright © 2020 Heartfelt Creations, Inc. All rights reserved. This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.