Royal Dragonfly

 Save Project to My Library

Royal Dragonfly

Instructions:

Create base using outside Fancy Classic Rectangle Frame Die, cut two pieces from white cardstock and glue together on the top. Using frame die, cut from gold paper and paper collection, glue together making sure to offset them and place onto card using Foam Strips for dimension. Cut smaller frame from paper collection and gold paper, glue together making sure to offset them and adhere to the front of the shaped card using Adhesive Foam Strips for dimension.

To create Clematis flowers, stamp Clematis Cling Stamp on white paper with Ranger Archival Ink Pad - Majestic Violet and cut using the coordinating dies. You will need 2 petals of each to create flowers. For bigger flower use the biggest stamp, for smaller flower use smaller size stamp. Colour the flower with Ranger Archival Ink Pad - Majestic Violet using a sponge dauber. After colouring, place the flowers into the mold and run through cutting/embossing machine. Pierce the center and glue in some stamens using hot glue gun. Add a little hot glue to the underside of the flower. Add dries clear adhesive around flower stamen and sprinkle Ribbit Prills. Sponge the petals with dries clear adhesive and sprinkle with Rajni Chawla's Crystal-Clear glitter.

Stamp the leaves from the Large Floral Urn Cling Stamp Set on the white paper with Ranger Archival Ink Pad - Leaf Green, cut out with the coordinating die, shade use this same ink and shape. Sponge the leaves with dries clear adhesive and sprinkle with Rajni Chawla's Crystal-Clear glitter.

Stamp dragonfly and floral flowers using Dragonfly Florals Cling Stamp Set stamp on the vellum paper with Emboss – embossing stamp pad - clear and sprinkle gold engrossing powder, heat up to melt using heat gun. Using Decorative Dragonfly Die cut matching die cuts from paper collection and place onto the card using adhesive foam strips.

Stamp sentiment using Special Birthday Sentiments stamp on the front of the card with Emboss – embossing stamp pad - clear and sprinkle gold engrossing powder heat up to melt using heat gun. Arrange flowers and leaves around as shown, using foam adhesive and hot glue.

Other Products: Dimensional adhesive, hot glue, hot glue gun, scissors, paper trimmer, die cutting machine, white cardstock

Created By Ewelina Panka
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.