Bright Sunshine colour cloud ink - cosmic shimmer, Grapefruit Grove, so saffron and mint macaron ink pads - Stampin Up! Gorgeous Grape card stock - stampin up! Foam pads
For more tips on creating with the Purr-fect Posies collection, watch the tutorial at https://youtu.be/88KR6a5RRmg.
Score an 8.25" x 11.5" piece of Gorgeous Grape card stock at 5.75" to give a 5.75" x 8.25" card base. Select a paper from the collection, cut slightly smaller than the card base and adhere it using dries clear glue.
Cut 2 of the floral strips from the paper collection and adhere these to the card base at the top and bottom of the card approximately .5" from the edge of the card.
Select and cut your central image from the paper collection and adhere to a piece of gorgeous grape cardstock. Diecut 2 of the regal pockets using coordinating paper and adhere these to the back of the central image, then adhere the image to the centre of the card base using foam pads.
Dot nuvo crystal drops as shown on the example and set aside to dry thoroughly.
Make the leaves: Stamp onto the flower shaping paper using mint macaron ink, colour lightly with the same colour ink and die cut. Place face down into the mold, put the lid on top and run through the die cutting machine to shape the leaves.
Make the flowers: Stamp the 3rd and 4th (largest) sizes onto the flower shaping paper using so saffron ink and colour in the centre fading the colour out towards the edge. Stamp the 1st and 2nd sizes in Grapefruit grove ink and colour using Bright sunshine colour cloud. Die cut the flowers and colour the reverse of the smaller petals with the bright sunshine ink. Place the flowers into the flower shaping mold face down, spritz with water and place the lid on top then run through the die cutting machine. Make a hole in the centre of each flower, matching the 1st and 3rd and the 2nd and 4th petals, and thread a stamen through the darker and lighter petals. Hot glue into position. Sponge dries clear glue onto the flowers and dip into the transparent glitter, set aside to dry, then snip off the excess stamen stalk from the back of the flower.
Die cut the sentiment and cover in 3d crystal lacquer, allow to dry.
Position and hot glue into the place the flowers, leaves and sentiment.