Peony Hug Banner

 Save Project to My Library

Peony Hug Banner

Instructions:

Mat and layer to fit DL card base (4 x 8 1/4”) Floral Banners Paper Collection sheet 6B onto sheet 12B edged with Vibrant Fuchsia. Adhere 6B edged with Vibrant Fuchsia to the inside of the card. Die-cut Eyelet Lace Frame in 12B edged in Vibrant Fuchsia and adhere to the inside of the card. Die-cut Eyelet Lace Frame in white, stamp and edge in Vibrant Fuchsia ‘It’s Been a While’ sentiment and adhere to the inside of the card.

Stamp onto white cardstock in versafine onyx and clear heat emboss, Peony & Sunflower Banner, Peony Bud and Blossom and leaves from Large Sweet Peony. Die-cut and colour leaves in Vivid Chartreuse, Leaf Green and Fern Green.

Use Zig Clean Colour Real Brush Markers and water pen to colour the banner and flowers. Die-cut Ornamental Tag from the Floral Banners Paper Collection 12A, mask off to stamp ‘Hug’ onto the tag in Jet Black, edge with Vibrant Fuchsia. Adhere a bow using hot glue.

Stamp in Jet Black onto white cardstock ‘sending you a hug’ setiment die-cut with Peony & Sunflower sentiment strip, edge in Vibrant Fuchsia. Stamp a further 3 blank white sentiment strips, adhere together then directly to the banner.

Loop ribbon cord onto the front of the card prior to die-cuts using Dries Clear adhesive and dots for dimension, adhere the Peony & Sunflower Banner across the bottom of the card on triple dots.

Add some gems and Wink of Stella to Peony & Sunflower Banner for sparkle.

Other Products: Paper trimmer, hot glue, versafine onyx, clear heat emboss powder, ribbon cord, bow, gems, Wink of Stella Clear

Created By Lynn Stanborough
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.