Magnolia Branch

 Save Project to My Library

Magnolia Branch

Other Products: Hot glue, trimmer/scissors, pearls/gems, floristry tape/wire

Instructions: Remove a panel from the 5 x 7” Gateway Fold Card Blank. Adhere the outline from Scalloped Flourish Gateway Die Set in Sweet Magnolia Paper Collection to the front of the card, then layer an Eyelet Frame Gateway Die and Lattice Flourish Gateway Die in white cardstock. Adhere the lower section on dots and add gems and pearls.

Adhere the outline from Scalloped Flourish Gateway Die Set in Sweet Magnolia, then Lattice Flourish Gateway in white cardstock. Mat and layer alternate Eyelet Frame and Plain Frame, finish on dots stamped ‘To the world you are one person but to me you are the WORLD’ in Cactus Flower. Adhere to the inside of the card.

Stamp in Cactus Flower onto Deluxe Flower Shaping Paper Sweet Magnolia Blooms, colour the edges and backs in the same colour. Stamp out in Leaf Green the leaves and small petals for the buds. Spritz and add to the Magnolia Shaping Mold and run through the die-cutting machine. Use the Deluxe Flower Shaping Tool Kit to curl into buds and adhere the petals together with hot glue. Poke a hole through the centre and thread stamens through securing with hot glue behind the flower and trim off surplus cord. Add floristry wire (or surplus stamen wire) to the flowers and buds and wrap in floristry tape. Secure the branch with hot glue.

Stamp in Cactus Flower onto white cardstock ‘Just wanted you to know’ place Banner Die over and die-cut, edge in Cactus flower and using the Flower Shaping Tools curl the banner and secure around the branch.

Created By Lynn Stanborough
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.