Lattice Wall

 Save Project to My Library

Lattice Wall

Instructions:

Score and fold a 12” x 5.25” piece of white card at 6” to create a tent fold card, place the largest Lattice Swirl gateway die over the fold and die cut to create a shaped card base. Use the largest Lattice Swirl gateway die to cut paper from collection and layer onto a white die cut of the same shape. Adhere this to the card base. Die cut a white and pale green decorative Lattice Swirl gateway die and adhere them on top of each other, slightly offsetting, onto the card base.

Make the flowers: Stamp 2 large, 2 medium and 3 small floral stamps using bumble bee ink onto flower shaping paper, color the center using lilac posies ink and the remainder lightly with pale papaya ink, die cut. Place face up into the shaping mold, spritz with water and run through the die cutting machine to shape. Layer 2 sets of petals together, offsetting, to create each flower. Place a drop of hot glue into the center of each flower and cover with a penny saved prills, remove excess when cool.

Stamp the leaves and 2 stems onto flower shaping paper using fern green ink and color lightly using bamboo leaves, add a small amount of sweet plum ink to shade, die cut and lightly edge with bamboo leaves. Shape the stems by hand using the flower shaping tools and the leaves face down into the shaping mold (these can be shaped at the same time as the florals).

Position the stems, flowers and leaves to one side of the card and hot glue into place. Sponge with dries clear glue and sprinkle with transparent glitter.

Stamp the sentiment using black ink onto white card, die cut using a circle die and adhere to the card base using foam pads.

Other Products: Bumble bee and pale papaya ink pads - Stampin Up!, white card, foam pads, hot glue

Created By Cheryl Morgan
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.