The size of this layout is 12" x 12“. Taking the pizza box or grey board, cut to 12" x 12" for the  base. Taking two papers from the paper collection, sheet 2B. Cut both papers in half, adhere the solid red paper print to the base. Trim the remaining paper with the white lace print so it will be about 1 / 4 “ smaller than the base when adhered. Taking the paper distressing tool, distress the edges that will be showing when adhered. Adhere in place with 3D double sided foam tape so the white lace will be in the middle of the page.

Make the poinsettia flowers and the embellishments for this layout by stamping with VersaMark and heat embossing with the gold embossing powder on to the flower shaping paper, colouring with colours listed in the product list: Sunflower, Red Geranium, Library Green. Once the coloring is done, die cut and shape with the matching dies and molds. The poinsettias are made with two petal layers for each flower, two largest sized, three smaller sized, one of smaller size down and two of the smallest size. Seven holly leaves, five of the largest swirl clusters, six of the small holly swirl clusters, eight small leaves clusters, the last being stamped with the VersaMark and heat embossed with the gold embossing powder only. One Ironworks sentiment diecut.

Choose a photo that fits the layout, cut the photo to size if needed and back with grey board to strengthen the photo. Sand the edges of this photo to give it a white edge and adhere. Once the flowers and other elements are made you can arrange them as pictured and adhere in place using the hot glue gun or the clear drying adhesive, adding the swirls and leaves as fillers where needed.

Trim the hearts off the top of the diecut sentiment and adhere under the photo. Adhere the remaining part of the sentiment to the right of the layout under the flowers. Apply the diamond stickles to the sentiment .