Classic Birthday Blooms

 Save Project to My Library

Classic Birthday Blooms


The finished card is a shaped card measuring 4 1/2" x 7". Using white cardstock make a shaped base card using the dies from the Fancy Classic Oval Frames set. Cut another piece of white cardstock to cover the shaped base. Cut a piece of Sheet 6B of the paper collection and cover the card front. I used white cardstock and a smaller die from the set to make the medallion. Also cut a piece of Sheet 11B then clue the two die cuts with the turquoise showing a bit under the white piece. Glue down to the card front. I used the next smallest oval die and cut out another piece of Sheet 11B and glued it to the medallion piece.

Stamp the sentiment onto a piece of 4A using Jet Black ink. Use the tag die from Cut Mat Create set and cut out the sentiment. Also cut a piece of white cardstock and glue the sentiment piece to this. It just gives the sentiment a bit of stability. Use Double Dots to adhere to the card front.

Stamp the flower petals using Magenta Hue ink and cut out using the coordinating dies. Stamp the leaves using Fern Green ink and cut these out using coordinating dies. I used the stack and store daubers to color the leaves with Leaf Green ink and then edge with Olive ink. Color the flower petals with Magenta Hue ink. Lay the flower petals and the leaves onto the shaping mold and sprintz with water then run through the die cut machine. Turn everything out onto the desk to dry. Once dry use a hydra sponge and Dries Clear Adhesive to add glitter to the flowers and leaves. Also at this point add the prills by adding a puddle of dries clear adhesive to the center and then dumping prills over. Allow to dry.

Once everything dries, decide on placement and use hot glue to glue to card front. The card is finished.

Other Products: Die Cut Machine, Hot Glue Gun, White Cardstock, Dimensional Tape

Created By Glenda Brooks
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.