Cascading Magnolia

 Save Project to My Library

Cascading Magnolia

Other Products: Foam pads, hot glue, Berry Burst and old olive inks – stampin up! 7” x 5” white card base, clear embossing powder, foam pads, hot glue

Instructions: Cut a paper from the collection slightly smaller than the card base and edge with berry burst ink, adhere to the card base.

Die cut the circle die using white card and adhere to the top of the card using foam pads.

Stamp the sentiment onto the tag using berry burst ink, cover with clear embossing powder, remove excess and heat to set. Die cut the tag and adhere to a white die cut of the larger tag, adhere this to the card as shown using foam pads

Stamp the Sweet Magnolia flowers onto flower shaping paper using the berry burst ink and die cut. Add berry burst colour from the inside centre fading out to the edge on both sides of the petals. Place face down in the shaping mold and spritz with water, run through the die cutting machine to shape. Create a hole in the centre and thread a stamen through 2 sets of petals, secure with hot glue and snip off the wire at the base of the flower.

Stamp the leaves using old olive ink, colour with new sprout and diecut, add shade using the old olive ink and place face down in the shaping mold. Spritz with water and run though the die cutting machine to shape.

Position the leaves and flowers and secure into place using hot glue. Add a little dries clear adhesive to the edges of the flowers and sprinkle lightly with baby’s breath glitter.

Created By Cheryl Morgan
Copyright © 2021 Heartfelt Creations, Inc. All rights reserved.