Other Products: Ribbon, Stickles-crystal, M.S. Border Punch, EK Heart Punch, Pearl Halves, Viva Perlen-Pen-Ice White, copic markers
Watch this video on tips to create the roses.
Instructions: Open card is 24 X 6 1/2" closes to 6 X 6 1/2". Cut 1 piece of 12 X 12" plus 1 piece 6 X 6" white heavy weight card stock in half. Glue 1 piece of 3 X 6" piece to the end of each 12 X 6" piece then score each 15 X 6" piece at 3", 6" and 9" leaving the end at 6". Glue the two 6" pieces together (sandwiched together to make one 6" center). Mark 2 1/2" from the bottom on both ends and cut from mark up at an angle to the top within 1/4" of the last score (leaving the center 6" piece whole). Do this on both sides. Cut light pink designer paper to fit each inside panel. The Wedding couple and arch designer paper is in the center. Cut medium pink to fit each panel on the back side.
Stamp Classic Rose flowers in Pearlescent Coral and color using Stack and Store Daubers using same ink and shape as shown in video. Stamp Classic Rose Vines in Bazzell inks-Light Green ink, diecut and color using New Sprout ink. Die cut two Medallions and four Small Fleur Pockets on white cardstock. Adhere one pocket to each short side inside and outside too, only applying glue to the 2 outside edges of each piece.
Glue one Medallion to each side of the 6" center. Use a border punch to cut enough border to top the card from end to end. Score border at card scores to make folding easier. Glue ribbon to top inside and outside, make sure you can still fold card nicely. Shape, color roses and leaves. Add Crystal Clear to the tips of roses. Adhere some of the Classic Rose vines to the inside (second section on both sides) and then close card to adhere roses so that none are under any layers when closed. Add a small swag of leaves and roses to the center at the top of card. Add Perlen-Pen babies breath to floral on the center panel and add Stickles to the roses. Fussy cut tags from the Classic Wedding designer paper and add ribbon to tag and tuck into inside pockets. Add large pearl halves to the outside ends and small pearl halves to the glued down pockets on the outside ends. Use Perlen-Pen "pearls" to the inside pockets.
To make the band cut 12" strip plus 3" strip 1 1/2" wide then glue together. Wrap around card to get where the scores should be. and then glue ends together. Cover with medium pink designer paper 1 3/8" and long enough to go around then add ribbon to center all the way around. Cut a strip of white cardstock wide enough to cover center glued piece and border cut both sides. Punch a heart for the center. Stamp heart wreath and wedding rings in black ink onto white cardstock, diecut and color using copic markers. With a scissors cut large ring at about the center and add to wreath (make sure cut is covered by wreath vine), glue to band just in a few places so that it keeps it's form. Add Stickles glitter to diamonds. The band keeps the card closed nicely and adds a decorative punch for interest to the closed card.
Created By: Robin Clendenning