Woodsy Scene Tunnel Card
Woodsy Scene Tunnel Card
Other Products: Card Stock: Rose Beige, Aquarelle paper; Ranger: Stardust stickles, Inking foam tool, Bone folder, Water coloring brush, Paper, Scissors, Distress Inks: Forest moss, Tumbled Glass, Broken china, Faded jeans, Mowed lawn, Derwent Ink-tense watercolor pencils: Deep rose-0710, Tangerine-0300, Sun yellow-0200, Crimson-0530, Charcoal grey-2100, Bark-2000, Amber-1710, Saddle brown 1740, Sherbet lemon-0100, Sepia ink-2010, Dark chocolate-1930, Felt green-1530, Light olive-1540; Other: Archival black ink, Versa-mark, Fussy Cutting Scissors, Double sided Tape, 72 cm Organza ribbon, Scoreboard
Instructions: The finished size of this project is a little over 15 cm x 15 cm. To make the tunnel base, take the card stock and cut (x 4) 15 cm x 15 cm. From 3 cut a hole into the square to form a frame. The cover frame edge is 2.2 cm. The remaining two are 3 cm and 1.5 cm frame edges. The supporting box the measurements are, 15.1 cm x 15.1 cm for the base, 3 sides at 2 cm, 1 side at 2 cm + 1.5 cm (this is for the front frame hinge). Ink the edges using the different colored inks. Green inks for the ground and blue inks for the sky. Adhere all together to form a box with a hinged cover. Adhere the ribbon to the side of the box. Make a sentiment using the ‘Thinking of you‘ stamp from the Paw-fect Pooches stamp set. To make the inside, Stamp all the images from the collection with the archival ink on aquarelle paper. Color the images with the watercolor pencils then die cut the images. Arrange across the openings of the frames. Checking that you will see the treetops and critters in each layer by placing on top of each other before adhering in place. Once there is a base line of tree lines and bush you can then add the critters and birds. You can trim to size the flowers and forest foliage as fillers. Once all is glued and secure on the frames, you can adhere the frames together in a stack. Adhere two foam dots together to form one dot to give the height needed between each frame. The dot placement is three across on each side. Because you have used ink you will need to add a spot of wet glue to the foam dots to secure the hold. Once you have adhered the entire frame together, add double sided tape to the base and sides of the box. Place the frames into the box, tie the ribbon, add the sentiment and embellish the frame front. Add a few spots of stickles here and there to add interest.