Other Products: Card Stock: Green (Parakeet), Crafters Companion A4 Whit-hint of gold 300gm., Ranger: Orange peel Stickles, Heat Gun, Water Mister, Inking foam tool, Bone folder, Water coloring brush, Paper-distressing tool, Scissors, Distress Inks: Forest moss, Mustard Seed, Black Soot, Honey yellow, Old paper, Antique linen, Mowed lawn; Other: Black archival ink, Versa-mark, Double sided Tape, Double Sided Foam Tape, Scoreboard, Misti, Hot glue gun, Cocktail stick, Creative Embellishments "Hope"
Watch this video https://youtu.be/quxqv6wJRic to see how to create Delightful Daisy flowers.
Instructions: This Z slider card fits into an envelope that measures 22 cm x 21 cm when completed. A4 cardstock is used to make the 17.5 cm x 21 cm Z slider card. To make the card base, taking the A4 cardstock and score at 6 cm and at 12 cm along the long edge. Fold into valley and hill folds. This will form the card front foot (6 cm x 20.8 cm) and card front background (17.7 cm x 20.8 cm). For the slider, cut 11.5 cm x 7 cm. For the card front cut 14 cm x 17 cm. For this card, the white base is inked with forest moss distress ink. This ink lets the pearl base show through. All the matting layers will be cut at 2 mm smaller each side. Cut one matting layer in each of the green card stock and the design paper found in the paper pad to fit all the card base elements. Ink the edges of the design paper with forest moss ink. Adhere all the matting layers together, except the top edge of the card front and the first matting layer. This is so you can slide the slider between the card stock layers. If you forget to do this, don't panic. Then you make a band measuring 16.5 cm x 2 cm and adhere to the top back side of the card front. Use this for the slider guide; adhere to the back of the card front. Fixed. Adhere the slider to the top center of the card background front. (Make sure you do not place the glue and double-sided tape too low. If you do this, the card front will not sit flat when closed. If this happens, make a slider guide for the back and place it lower in the back.) Adhere the card front to the center of the card foot. Slide the slider in to place.
Make and adhere all the embellishments to the card front. First stamp and make the flowers. The stamping for the flowers is done with the gold embossing powder. When shaped with the flower shaping kit, add the clear drying glue to the tips of the daisies, then dip into the glitter. Put aside to dry. When dry tap off the extra glitter.
Cut the leaves and sentiment banner using the Cut-Mat-Create die set. Ink the edges of all of the elements. Stamp the sentiment. Color the cocktail stick and adhere to the back of the sentiment to look like a post. Stamp the Pooch and his bones. Die cut the images and extra 4-6 times extra to make chipboards from the images. Adhere all together. Taking the Creative Embellishment "Hope" word, apply the clear drying glue to the front of the word then dip it into the glitter. Add a second layer if needed. Put aside to dry. Once all the layers for the card base has been put together and the "Hope" is dry, you can now adhere all the embellishments for the card. First adhere the bones to the lower card front, then the Pooch to the center using the aid of foam 3d dots to keep the height even. Adhere the daisies and leaves then the sentiments. Take note: When adding the slider decoration, make sure the slider still slides before securing with glue.
Created By: Susan Smit