Gallery Print Project Ask Question


Paw Prints And Bone Flower

Other Products: White Card Stock, Spellbinders: Antique Frame & Accents, Petite Labels One, Ravenna Dies, Versamark, Clear Bark Embossing Powder and die cutting machine

Instructions: To make this 5" x 7" card start by taking a piece of White card stock 7" x 10" and scoring at the 2 1/2" and 7 1/2" marks. Layer the front with panels from the Pampered Pooch Paper Collection and layer the inside with a die cut from Spellbinders Ravenna using paper from the Pampered Pooch Paper Collection layered with a pre-made panel from the same collection. On the front, 3 of the largest paw dies cuts were added. The top and bottom ones were glued on 1 side of the gate fold and the middle paw was glued on the other side. Also, two strips from the Spellbinders Antique Frame & Accents were added up the sides and the front was finished with a die cut from the Arianna Lace Die covered with a dog bone flower.

The flower was created by stamping the bones from the Paw-fect Pooches Cling Stamp Set on white cardstock with Versamark and heat embossed with Clear Bark Embossing Powder and cut with the matching die. The recipe for the flower is 2 of the large bone and 6 of the smallest bone. Once all the bones were die cut they were shaped with the Deluxe Flower Shaping Kit. For the sentiment, it was stamped on white card stock with Versamark and heat embossed with Clear Bark Embossing Powder and cut with the Cut Mat Create 1B Die before attaching as shown.

To finish off the inside panels, stamp the small paw prints with Rich Cocoa ink and finish the inside with a sentiment strip from the Pampered Pooch Paper Collection.



Created By: Joann Jamieson-Larkin



Arianna Lace Die
HCD1-747

$29.99

Spellbinders Tool N' One
359848

$14.99

Cut Mat Create 1B Die
HCD2-750

$34.99

Deluxe Flower Shaping Kit
HCST1-401

$39.99

Paw-fect Pooches Die
HCD1-7116

$29.99