Gallery Print Project Ask Question


Snowflake Card And Tag Gift Box

Other Products: Navy card stock, Curious Cryogen metallic card stock, ATG, Pearls, Gem, Copic B00 and N1

Watch this video https://youtu.be/Gnaj5vc8_b0 to learn how to create the gift box.

Instructions: For the card, begin with a 5.5" x 5.5" navy blue card base. Using the outer snowflake die from the Snow Kissed Flakes and Tag set, center the die onto your card front and then run through your die cut machine only half way. Trim your card stock above and below the snowflake. Trim a piece of snowflake paper from the Snow Kissed Paper Collection to fit on the left side of your card front; temporarily attach and then tape the outer snowflake die down to this panel. Remove the panel and run it through your die cut machine then mount to the card front. Die cut two of the large snowflakes from Cryogen metallic card stock. Using Designer Dries Clear  Adhesive, attach a snowflake to the front and to the inside of the card. Add some pearls and a gem to the outer snowflake and card front. Create another small snowflake paper panel to fit the inside of the card front following the same instructions as above. Find the paper panel with the snowman in the lower right, trim to 5 3/4" x 5 3/4" and adhere to the inside of the card. Trim out the sentiment, back with navy card stock and mount to card. Stamp an assortment of snowflakes with Memento Danube Blue ink and die cut with the coordinating dies. Attach to the card with Designer Dries Clear Adhesive. Using Memento Danube Blue ink, stamp and die cut the tag from Cryogen metallic paper. Add some color with Copic B00 and N1. Die cut two Gift Boxes from navy card stock and assemble. Add snowflake paper panels to each box; a sentiment ticket and snowflakes. Add a 1" strip of navy card stock inside the edge of one of the boxes to create a tab for the second box to slide over.



Created By: Sandy Hulsart